Description
HUBA CONTROL
604.99352
MECHANICAL PRESSURE SWITCH
0.2-3 MBAR
MAX.=50 MBAR(-30T85)
SWITZERLAND
The Huba Control 604.99352 is a mechanical pressure switch made in Switzerland, rated for a 0.2-3 mbar switching range and a maximum pressure of 50 mbar. Within shipboard control equipment it acts as a pressure-sensing contact, changing state when the monitored pressure reaches its set point so that the connected control circuit can start, stop or alarm. Alongside the pressure ratings, the switch carries a -30T85 marking. It belongs to the low-pressure monitoring side of vessel control systems, where small pressure changes must be turned into a clear on or off signal. This unit is supplied in used condition.
Key Features
✓ Mechanical pressure switch
✓ Switching range 0.2-3 mbar
✓ Maximum pressure 50 mbar
✓ Marked -30T85
✓ Made in Switzerland
Marine Applications
✓ Low-pressure switching duties in vessel control panels
✓ Pressure-dependent start, stop or alarm signals in automation circuits
✓ Spare switch for control equipment using the 604.99352
Technical Support
Prota Marine provides technical support, repair and onboard installation for the mechanical pressure switch and the wider marine control system. Our engineers can carry out fault diagnosis when switching becomes erratic and give commissioning support once the switch is back in service.



