Description
CARLO-GAVAZZI
G5010 1106
DUPLINE TRANSMITTER
TECHNICAL SPECIFICATIONS:
INPUTS: 1 CONTACT
OPEN LOOP VOLTAGE: 2.5 VDC
SHORT-CIRCUIT CURRENT: 17 ΜA
OPERATING TIME FOR SIGNAL “1”: < 1 PULSE TRAIN + 10 MS
OPERATING TIME FOR SIGNAL “0”: < 1 PULSE TRAIN + 500 MS
CONTACT RESISTANCE: < 1 KΩ
INPUT PULSE PROLONGATION: MIN. 272 MS
CABLE LENGTH: < 3 M
DIELECTRIC VOLTAGE INPUT – DUPLINE®: NONE
POWER SUPPLY: SUPPLIED BY DUPLINE®
CURRENT CONSUMPTION
WITH LED OFF: TYP. 450 ΜA
WITH LED ON: TYP. 1.2 MA
The Carlo Gavazzi G5010 1106 is a Dupline transmitter used in marine control system installations. It takes the state of one contact input and places that signal onto the Dupline bus that links field points with the control equipment. The module draws its power directly from the Dupline line, so no separate supply is needed. On board, units like this collect switch and contact status from machinery and alarm points for the vessel’s control and monitoring electronics. It is supplied new without box.
Key Features
✓ Single contact input
✓ Open loop voltage 2.5 V DC, short-circuit current 17 µA
✓ Operating time below 1 pulse train + 10 ms for signal 1
✓ Minimum input pulse prolongation of 272 ms
✓ Powered by Dupline, typical 450 µA with LED off
Marine Applications
✓ Contact status signalling over Dupline networks
✓ Machinery alarm and monitoring inputs
✓ Remote on/off indication from switch contacts
✓ Distributed inputs in engine room control systems
Technical Support
Prota Marine provides technical support, repair and onboard installation for the Dupline transmitter and the wider marine control system. Support covers fault diagnosis on Dupline input points and commissioning support when the transmitter is brought into service.
